Wood veneer veneer hot press, panel veneer multilayer woodworking machine hot press is a woodworking machine equipment, most of which are aimed at woodworking boards. There are mainly solid wood multilayer boards, plywood, composite boards, honeycomb boards, foam boards and other boards on woodworking boards. The name of the hot press is as follows: ecological board press, plywood hot press, etc., because each company produces different products.

The woodworking hot press is a common woodworking pressing plate equipment among wood furniture manufacturers, which is not unfamiliar to everyone. The furniture veneer hot press is a woodworking mechanical equipment, most of which are aimed at woodworking boards. The veneer pressing of woodworking boards mainly includes solid wood multilayer boards, plywood, composite boards, honeycomb boards, foam boards and other boards. Wooden veneer hot press is also the main equipment of our factory. Today, we will popularize some common problems of hot press in furniture industry. The veneer hot press is basically suitable for the size of wood-based panels. The panel pressure is usually 0.5 MPa, and the corresponding total pressure is about 100 tons. In addition to the main technical parameters such as the size of hot platen, total pressure, number of layers, and plate pressure, the veneer hot press also has other technical parameters such as opening distance, closing time, heating temperature, etc. The operator can choose according to different process requirements.
1. If the heating temperature does not rise, check whether the heat transfer oil is normal and check whether the heat transfer tube is blocked;
2. After heating, whether it can automatically stop and stop heating after reaching a certain temperature. If it cannot automatically stop heating or keep the temperature constant, it is necessary to detect the stop travel switch. This is generally the case
3. The equipment cannot be raised or lowered normally. This is a circuit problem
Comparison of heating methods between wood veneer hot press and traditional hot press:
1. The traditional heating method of woodworking hot press is steam heating or electric heating. The steam heating is fast, but the pressure cooker is required. The pipeline pressure is high, and the steam is easy to condense into water to form uneven temperature on the board;
2. Electric heating has the characteristics of fast temperature rise, high heating temperature, easy control, etc., but it has large power consumption, high operation cost, and it is difficult to replace the resistance wire when it is used in detail.
3. The advantages of heat transfer oil heating are: high heat capacity, average temperature, and it can be heated to a very high temperature under normal pressure. The heat consumption is small, and it can be * * *. The problem is that the heating speed is slow, and it is not easy to stop temperature control.